Painting the Panel
Nothing to fantastic here. I put my screws in a piece of
cardboard so that I could paint them too. Then I masked off the
panel and primed and painted it.
One note about priming. This was my first experience with DX-1791
primer. I was told to NOT put it on too thick, as the etching
chemicals need to react with the metal. If you put it on too
thick, after you paint, eventually the un-used chemicals will cause the
paint to come off in sheets. On my first spraying, I had it WAY
too thick and hated how it turned out. I used Acetone or MEK and
wiped it all off and then re-shot ti. Turned out great that time.