| Changes out the 8 screws in the upper two trays that were interfering with the install of th audio panel and the Transponder. |
|
| Then mounted the Dynon D10A back-up EFIS. (I need to make an adjustment to get it level) I have also decided that I'll mount |
|
| the Digiflight ll VSGS autopilot on the top of the stack, I checked and there's room for it there, that left a little more uncluttered |
|
| room @ the bottom of the stack so I didn't have to jam the Dynon down close to the ThrottleProp/Mixture controls. The only |
|
| thngs left to physically mount are 1. Autopilot 2. Pitch and rool trim indicators (will go on either side of the Dynon) 3. The 1 1/4 " |
|
| airvents from Stein. 4. Headphone jacks. 5. 12v Aux power receptical 6. Pilot & co-pilot headphone jacks. 7. Switches 8. TPM |
|
| controls and heating vent cables. 9. Remote Waas GPS sensor. Time to now start to figure our the wiring runs and harnesses |
|
|
|
