| Finished up wiring the last of the RS 232 connections to both the EFIS and the MFD, needed to run out and get a little more |
|
| shielded 3 conductor and some 4 plug Molex connectors. Go those done and cleaned up some wiring runs. Then ran continuity |
|
| checks on all of the EFIS/MFD connections to the various devices they connect to. Found one problem with pin put in wrong |
|
| location, good thing I checked. Tomorrow, I'll connect all of the grounds to a temp grounding point and then put some power to |
|
| the panel and begin the configuration/checkouot process (Hopefully, if I don't blow something up 1st!)) |
|
