| Wired the autopilot to the EFIS (only gets wired to Primary) Also wired the EIU to the EFIS & MFD, put Molex disconnects |
|
| between both units and the EFIS screens. Finished wiring the pilot-side headphone and mic plugs. Fabricated a 'daisey chain' to |
|
| power the lights on the lighted rocker switches. These will get connected to one of the perhilion dimmer switches. I was sweating |
|
| how to mkae these connections so that the switch panel and the switches could be removable for maintenance. There are 'tabs' |
|
| on the rear of the switch but the are slightly smaller than the 'fast-on' tabs, I thought about soldering and then putting crimp tabs |
|
| on the wire, but that would have been a wire mess. It turns out that I can compress the terminals and achieve a really tight fit with |
|
| these crimp terminals. I'm going to do the same tomorrow with the + and - leads for the switches them selves. |
|
