Began today by cuttin gout the fiberglass behind the switches so that the switch/flap panel can be installed. Next task was to |
|
create a mounting panel from .0625 for the autopilot, some additional switches and the trim indicators. 9I'm not going to install |
|
the trim rocker switches, as I'll have those functions wireed to the hat switch on the control columns. I'm short a switch that I |
|
forgot when ordering last week, so that's anothe call to pac coast avionics. I installed the mounting plate to the center console |
|
with 6 "6 nutplates and then countersunk the attachment holes, then proceeded to drill/cut and file all of the holes to mount the |
|
above. I'm glad that this step is clolse to over ad my fingers are more than a little sore from the filing. I need to order some panel |
|
lighting rheostats.dimmers and install them, and then I think I can complete the remainder of the initial panel wiring (minus the |
|
|