| I needed to make a new mounting plate for the lighted rocker switches, because the old one was too narrow to allow for the |
|
| snap-in switches. I' went back and forth on whether or not to use these, and I even ordered the conventional toggle switches |
|
| from B&C. But, I want this panel to look nice, and the old toggle switches are a little too mechanical, So I popped for the more |
|
| expensive but more attractive rocker switches. I'm short some of the caps that are being engraved, they should arrive in a |
|
| couple of weeks. I've also got 5 additional switches that will be mounted below the autopilot on the center console. Fitting those |
|
| will be tomorrows job. Like everything else this took way more time that I figured, but I was afraid of runiing the part, each |
|
| individual switch hole got drilled, step drilled, and then filed to final size after several test fittings, turned out OK, and will look |
|
| even better when the mounting panel gets painted along with the rest of the instrument panel inserts. |
|
