| Mounted the Dynon remote magnetic sensor on the same platform as the Crossbow AHRS, and then ran the wires that came |
|
| with the harness back to it from the forward fuse. Got everything connected by inserting the wires into the D-Sub connector, |
|
| Mounted the sensor using stainless steel hardware, used some standoffs to get the connector high enough to clear the alum |
|
| angles. Then ran the wire from the strobe panel switch to the strobe power supply. The dynon remote mag sensor will require |
|
| some adjustments after the panel gets it's final mount as the sensor needs to sit at the same angle as the D10A, should be an |
|
| easy thing to do by using some washers under the stand-offs. |
|
