Primed the upper fwd fuse after building it up to match the cowl yesterday, I rolled this one with a roller brush, because it was a |
|
narrow application, However it leaves too much of a knap and oddly doesn;t distribute the primer as evenly. I think the best |
|
application is w/ spreyer even if it does waste more primer. Did the credut card squeege trick before rolling it one, but still took |
|
several coats to fill the 'knap inconsistencies. Cleaned up the forward edge with a file. I need to refit the Axel extenders with the |
|
ones I got from Full Throttle Concepts (aka Rivethead). initially they were forcasting this was going to be an expensive part but |
|
Dave found some Alum stock that reduced the price Significantly. This requred removing the old AN washer that I had floxed to |
|
the inside. I ground away all of the flox I xould w Dremel, and then used a heat gun and they popped right off, Then Dremel to |
|
clean old flox off. 9Got too agressive on one pant and needed to add layup to reinforce. I had to remove the old Hex extender, |
|
and used Gary Specketers 'Jack" to temporarily raise the wheel to get the old on eoff and the new one on. Apparently i'm short a |
|
cotter pin, So only got one wheel done today. I |
|