| Worked on the left door today, filling and sanding, th etwo bottow corners require some filling and they are not easy to sand. |
|
| Filled and sanded the fwd and aft edges of the door jam about 3/4 of the way up. I needed to build up the bottom of the door to |
|
| match with the fuse so I needed to keep the hinges attached until that was finished. I also needed to add some filler on the upper |
|
| fwd fuse at the point where it mates with the forrward bottom of the door to make those two area flush. i applied some duct tape |
|
| to the forward edge of the door and then did the build up on the fwd fuse. That doen, I did the same i.e. used duct tape on the |
|
| fuse door sill and then did some filler build-ups on the bottom of the door to make everything flush. Tomorrow I'll take the doors |
|
| off and finish filling/blending the hinge pockets on the left door. |
|
