| Last couple of days, I installed the rear seats. pretty straight forward, I already had the half hinges made from 'a long time ago'. |
|
| Clecoed them to the bottom of the Aero Classic seats, match drilled, riveted and then installed. I covered the left rear window |
|
| trim ring in tweed, and temporarily installed it. I'm not really that impressed with the results. I held off doing the right side. I'm |
|
| going to wait until I install the headliner in the aft cabin , and then see if I feel any different, I may just eliminate tham al together. |
|
| I trimmed the aft baggage bulkhead to fit around the overhead plenum. I screwed up the 1st time, and took too much material |
|
| off, so I had to repair/replace the material and then recut the cutout to allow for the overhead. The whole baggage bulkhead will |
|
| be covered by an upholstered cover when done, so the repair won't show. I began to install an access door in the lower |
|
| bagagged bulkhead, but before doing so. I wanted to install a 12V outlet to power the Artic Air cooler I bought @ OSH. I |
|
| determined the lower right corner of the bulkhead was the best place. I made a doubler out of .040" and then riveted it in place |
|
| on the aft side of the bulkhead, Used a step drill to open up th ehols for the outlet that I purchased from Steinair. I needed to use |
|
| the deburrind swivel tool to open up the hole slightly to allow for a press fit of the 12 v outlet. I wired it to the same battery buss |
|
| that the overhead lights are wired to. |
|
