| Douing some fine tuning on the fit of the spinner and cowl. I ground off some more of the lower cowl spinner ring today and then |
|
| remounted the cowl 9even Judy commented on how easy it is to get on and off now). It looed great...... until, I remounted the |
|
| upper cowl, and then I noticed that the upper cowl was a smidge bit closer than the lower. That should be a little easier to fix, as |
|
| the build-up on the upper is filler and a bit easier to sand. Before remounting the upper, I put some mylar tape across the front |
|
| edge of the cowl where the induction rings connect with the spinner ring, when I remounted and screwed the upper and lower I |
|
| mixed up some micro/flox mixture and squeeged it in between the gap/seam when the two halves meet. The previous gap was |
|
| irregular and inconsistent and unattractive. before remounting I used a file and trued up the bottom edge oof the upper 9the one |
|
| that got the mylar tape applied. when the flox hardened I'll sand it flush, it should provide a nice clean match. |
|
