| The kids left to return to school this afternoon and I slipped back out to the garage and finished wiring the LED lights and |
|
| switches in the overhead console/plenum. Installed the fwd lights on their own circuit, tested everything, then cut to final length. |
|
| solder, shrink tube, and install in respective sockets. Then, attached pigtail wires to each of the rear seat lights and switches and |
|
| repeated the same process. with the exception for the wires in the immediate vicinity of the lights and switches all of the wire is |
|
| enclosed in the poly tubing to avoid it being whipped and worn by the pressurized air in the plenum. I'm a bit underwhelmed by |
|
| the amount of light these put out. I turned out all of the lights in the grage and turned on all of the lights, I does provide some |
|
| visibility, but not enough to read by, Which means that it probably will not have too great of an effect on night vision detiorization. |
|
| I still need to install the bagage area light and switch and install an 'inline' fuse to act as a battery buss for these lights. When the |
|
| O2 system arrives I'll install it into the overhead closure and that should complete the overhead. |
|
