| Began this morning by finishing off the door hardware, Primarily, ensuring the hinge attach hardware matched Van's plans. Then |
|
| I worked on the front seats. The front seats will not slide onto the seat rails, with the flap torque tube cover in place without some |
|
| modification. So I removed the nylon rail guides from the seats and cut a tapered section out of the top portion of each guide. I |
|
| measured about 1 1/2" back and then cut out the top portion of the guide. This allows you to install the seats by tipping the rea |
|
| portion of the seat up (clearing the flap tube cover) and then sliding the guides on the seat rails. I made some 'adjustments to the |
|
| seat rails. For some strange reason the platform that the seat rails mount to is not level, and this causes the seat rails to |
|
| bow/bend which in turn causes the seat to hang up on the rails. I adjusted it by raising the forward portion of the seat rails |
|
|
|
