| Began sorting out the remaining probes and sensors. Installed the Stainless steel firewall fixture from EPM. Attached all of the |
|
| sensor harnesses to the JPi box, found out that the JPI documentation is wrog and shows a couple of harnesses in the wrong |
|
| place, confirmed w a call to OP Tech. sorted which wires need to pass thru the firewall and routed them forward. I may have an |
|
| interference with the JPI EIU and the Co-pilot MFD, i'll know in a couple of days. installed all of the CHT probes using John Cox's |
|
| turbine high temp anti seize. I called BPE to find out where the Oil temp probe and the RPM sensor attach, The oil temp goes on |
|
| the back of the Oil Filter adapter in a hole machined for an 5/8-18 fitting, the problem is that my Oil temp probe if 1/8 NPT """ I |
|
| spent a fair amount of time looking for an adapter, and then found it easier to order a WESTACH sensor that has the 5/8-18 |
|
| fitting integral to it. will be here FRI. The RPM sensor goes on the Magneto vent that does NOT have a cap on it, doesn;t matter |
|
| which mag. John Cox will be here Fri/Sat and i'm hoping he can help me figure a good way to tidy up the wires forward of the |
|
|
|
