| I received the Probes and Sensors from Op Tech on Fri. so today, I mounted the Flo Scan fuel flow sensor. I also ordered some |
|
| closed cell split rubber foaam insulation to place over all of the 3/8" fuel lines inside the tunnel. This should help keep them |
|
| insulated from any 'Tunnel heat' and minimize any potential for vapor lock. Mounted the Oil Pressure sensor and the fule |
|
| pressure sensor to the firewall manifold and attached the VA 133 hose. Since I've got hoses w/ integral firesleeving, the outside |
|
| diameter is larger than Van's stock hoses. So I need to pick up some larger Adel Clamps tomorrow morning. I ran the Bowden |
|
| cables from inside the cockpit to the heater boxes, but didn't connect then yet. |
|
