| Spoke to Scott @ Van's yesterday, they received the engine mount and had determined that it ALREADY had the |
|
| modification/repositioning appllied to it. They were in the process of welding the new cross member in but it was too late to ship |
|
| back, So that means it won't arrive until Thurs or Fri of next week. (groan). So today was more preparation of the gear fairings. |
|
| Sanded the seam that was filled between the two halves and then completely sanded both main gear fairings. Mixed up some |
|
| SuperFil and squeeged it into as many pinholes and voids as I could see. then set them inside, as it's too cold (48) for them to |
|
| get a good cure in the garage. Rough trimed the flash off of the leg fairings and then sanded the otherside. Mixed up some |
|
| epoxy and applied a lay-up of single layer of .003 fiberglass tape on each leg fairing. Put them under the halogen lights for a |
|
| cure. They will get a sanding and then a coat of SuperFil applied to them, then sanded and then on to Smooth Prime. |
|
