| Not a lot of energy today, worked in several small increments. (all of this getting up and down from the ground dosen't make it |
|
| any easier) First off got the Right gear flox build-ups on the pants then put them under the lights for a quick cure. then had to fill |
|
| several voids in the Left forward flox build-ups. Meanwhile did the build-up on the Left rear gear pant for the axel attachment. |
|
| while that was curing, I drilled and attached the nutplates to the fwd portion of the Left gear attach bracket. Cleaned up the |
|
| Excess flox that spilled over the edges. Then pulled the Right fwd pant, it turned ut better completely filled, then did the flox |
|
| build-up for the Right axrl attach point, put it back on the lights. After it hardened sufficiently, I poped the washers off both rear |
|
| pants, there were a couple of voids that needed to be filled, sanded the washers and floxed then back in place, this time 'locking' |
|
| them in with a flox build-up around their perimeter. That's it for tonight. tomorrow I'll finish off the nutplates that connect the fowd |
|
| and rear sections and then finalize the mounting holes. If there is time left I'l start on the leg fairings. |
|
