| Began today by sanding the glass lay-ups of the rivet lines from ysterday and the flox around the inlet rings. Temoprarily |
|
| coupled the upper and lower halvres together to determine where some filling needed to be done. Basically along the horizontal |
|
| seams and accros the front on the lower cowl. I completely sanded the uper cowl w/ 100 grit preparatory to priming, I was |
|
| suprrised at how few pinholes there actually were in the upper cowl !!!! Good work Will James !. Then taped the upper horizontal |
|
| edge w/ duct tape (release). Rejoined the halves and applied Epoxy/Cabosil/Flox by squeeging it betwen the horizontal seams. |
|
| The CamLocs arrived today so I can complete the installation of the Oil door and get it faired in flush. I'm going to head to Las |
|
| Vegas to meet some old frineds from our home in No. Cal for a basketball tourney. so Priming probably won't happen until next |
|
|
|
