| 1st thing today, I replaced the upper cowl to see if the 'solution' for homing the pin into the hidden hinge worked. UREKA! it did! |
|
| REmoved upper and lower cowl, sanded the front edges of the lower cowl and applied duct tape (release) to the forward edges |
|
| of the upper cowl. Then inserted the hinge pins to bring them together and applied a 6 ply lay-up to the forward seam of the |
|
| upper and lower colw. When this is cured, I will trim it to an approproate ehight 1" to 3/4" above the lower cowl and then install 2 |
|
| #8 nutplates on each side which will allow me to bring the front of the spinner ring relatively flush. I expect that there will be some |
|
| Super Fil work to do to even out the joggle, but tihs is getting much closer. After this is done the next step is to install/flox ing the |
|
|
|
