| Didn't get much accomplished today. the heat has set back in (102) for the rest of this week, I put the tubes in the wheels and |
|
| put them on the main wheel hubs. per th eplans. Pretty straight forward. I also contacted Matco per some other builders |
|
| suggestings and arranges for a PMA to return the Van's supplied Nose wheel for one that provides for better clearance between |
|
| the valve stem. There was a slight up charge of $18.60 and the cost of shipping both ways. So boxed up the 'old' unmounted |
|
| nose wheel and sent it off via UPS. I should receive the replacement some time next week. The plans tell you to remove the |
|
| bearings, but I don't seee why this is necessary as it easu to split the wheel hubs without doing so. |
|
