| This is starting to sound like a broken record, Sand, mix flox, apply, wait to cure, sand, fill........ more of the same tooday, I think |
|
| that the Right door is pretty good, I'll remount it tomorrow after the morning sanding and check the clearance, The Left door will |
|
| probably require one additional touch up after tomorrow. Additionally I had my 1st experience with SuperFil today, its a Lot |
|
| thicker than I though almost like putty, which makes it a bit easier to work with than epoxy / flox / micro etc. It says it will adhere |
|
| to any clean surface including alum. I sanded the Flox seam between the cabin cover and the Fuse that I aplied yesterday, and |
|
| then applied a layer of SuperFil over both the right and Left doors. I'll let it cure overnight and we'll see how well it sands , it will |
|
| probably require a 'tough-up' application following this, I'm trying to get all of the duist generating stuff done by Sat, but I've still |
|
| got some work on the door skins themselves around the handles I installed and a repair where I had to cut out some of the door |
|
| to make room for the latch lever's. |
|
