| Sent the mount back over the weekend, so I'm looking for things to do to keep busy this week. One of them is to mount the |
|
| outlets for the overhead plenum forced air scat tubes, and to put in the snap bushings for the wiring. The bushings will need to |
|
| be sealed after the wires/cables are run. I also riveted the upright support. I forgot to do this befor riveting on the Cabin cover, |
|
| but after cutting the openings in the bulkhead for the Scatt tubes I was able to get my fingers in there and to put a small washer |
|
| in the back side of an LP4-3 rivet and pop rivet it in place. |
|
