| Relieved Console #3 so that it would fit flush with the other console assemly, then fiberglassed the armrest/mapbox to the other |
|
| components. MAde some posterboard templated so that i can cut out the .0625 inserts that fit into the panel. Fortunately with the |
|
| heat the console set up rather quickly and I was able to trim the glass and dress it. Removed the joined console from the fuse |
|
| and the alum rib cap, and began the extremely boring process if filling, and sanding, filling and sanding,filling and sanding......... |
|
| Started 1st w/ Bondo for the places needing to be built up, then switched to a sandable lightweight filler. The number of |
|
| compound curves on this beast makes it difficult as everything has to be broken down into small steps which deal with a single |
|
| surface at a time. Not finished with it, got the rear half done, need to continue tomorrow. Hope the finished product is worth the |
|
|
|
