| 1st off I finally riveted the fuel selector attach plate to the angles. I left them clecoed, but need to clean them up to start on the |
|
| center console. Then began to fabricate the center console. Lots of fiddeling around and not much progres to show. As its |
|
| working out I'm going to create the foam cores is 3 pieces, 1. The portion directly under the instrument panel, 2. the section that |
|
| surrounds the fuel selector, 3. the arm rest/map case/gloce box. I'm using some closed cell foam I got from Aircraft spruce, It's |
|
| too hard working with the individual side pieces, so I made a box that was close to the size and shape, was using 5 min epoxy to |
|
| join the pieces, but switched to bondo will be faster and just as good. Much easier to work with a 'cube' Got a good start on #1 |
|
| section, should be able to finish the shaping of that section tomorrow and get a start on the next. This stuff is really messy, and I |
|
| just got the garage all cleaned.....!!!! Oh well. |
|
