Made a major dent in the control system install. Nothing remarkable, the thing which took the most time was positioning the |
|
washers on either side of the rod ends inbetween the weldments. Takes some fannagling and some patience. I redid the initial |
|
installation of the Left control stick base, the weldment is too narrow for the brass bushing, and initially I tried to spread the |
|
flanges on the weldment, however when torqued, they bind a bit and cause friction in the controls. Th eplans tell you that it may |
|
be necessary to adjust the length of the bushing and the pivot tube. I did the Right by shortening the brass bushing to the correct |
|
length and then shortening the pivot tube, and the whole thing went in much smoother. I did put some washers in to take up the |
|
slack, The result is a friction free installation with no slop/play. |
|