Did some rework today, When attempting to connect the short pushrod to the control stick assembly, I discovered that I had |
|
onstalled the control rod backwards, and therefore the end with the hole drilled for the safety wire was on the other end!!!! This |
|
required disconnecting the pushrod from the ideler arm, and reversing it and then reinstalling. This was the one that gave me fits |
|
trying to get the small light washers inserted, so I climbed back in the tailcone and huffed and puffed and got them reattached. |
|
Before completing the attachment I needed to reinstall the rear mount bracket and the elevator belcrank assembly. But before |
|
doing this I needed to fabricate a new battery box that will hold 2 PC 680 Batteries. Got the dimensions off the web and some |
|
1/8"x 1 1/2x 1 1/2 alum angle from Ace hwdr. and began cutting, filling and sanding. All of the alum angles are cut and sanded, |
|
Tomorrow I'll drill and rivet them, then I can mount the elevator belcrank and install the push-rod to the control assembly |
|
(Whew, a lot of effort just to connect on rod end to a weldment!!!!!) |
|