| The door locks, and ignition switch/key's arrived today, so back to finish up the Bagage door. Deburr all the holes and edges, |
|
| Prime all parts. Cut the hinge and match drilled, deburred, and countersink, then rivet to the fwd brace. Then rivet the braces to |
|
| the outside skin and to each other. I 'back riveted them, but instead of using the back rivet set (not enough room) I used the long |
|
| handled bucking bar, that has a pretty long foot on one end, That and a 2 1/2 lb sledge, and 3 whacks later = a set rivet. Took a |
|
| little longer, but it's the only way I could figure to get it all riveted. Worked out fine, there were two rivets that were a little high, |
|
| dressed them with the Vixen file and on we go. Installed soundproofing, installed the lock and then pop riveted that inside skin. |
|
| Started on the attach to the fuse, but it's too hot, that will have to wait til Monday. Tomorrow & sun I'm going to the Nuckols |
|
| wiring seminar in Prescott |
|
