| Woked some more on the Wiring for the wings. Fabricated the roll Servo harnes and installed it through the conduit and |
|
| attached to roll servo. Also connected the pitot tube and ran the wires through the conduit for same, including the LED indicator |
|
| cable. Ran the shielded strobe cables through the conduit and installed the connectors on the wing tip ends. I need to get an AN |
|
| fitting tomorrow am so I can connect the nylon Pitot line i got from SafeAir. Also will run the wiring for the Duckworks lights and |
|
| install the power pucks for the LED position lights. After that the wings should be ready to button up after a Tech Councilor visit. |
|
