Asswemble and rivet the elevator trim tray, then install the trim servo and install, attach and adjust the trim cables. HAd some |
|
difficulty with the an4-7 rivets and had top replace one w/ an3 bolt, also the belcrank was too tight to allow for two washers, so I |
|
thined the belcrank using the belt sander and then put in 2 'thin/light' washers, allows for free movement with no binding. (Took |
|
too much extra time). Also the two F1095G brackets were too wide and interferred with the cables, used the dremmel to 'relieve' |
|
them where they rubbed against each other. |
|